Anmyz Industry Limited

---Stone Care Specialist

AZ-GL-6941 Slab Surface Epoxy


Product Detail

Mix ratio:A:B=4:1                       Color:Colorless and transparent liquid.                            




 Gel time(25℃,min): 15-25                                       

Hardening time(25℃,h):3-4                    

Tensile shear strength(MPa):≥8 

It can be used for the surface of marble to be coated with glue, which can repair the cracks and holes on the marble surface, and increase the surface brightness of marble after grinding.


[Product advantages]

1.High adhesion and strength, high penetration to small cracks,

2.Low odor, do no harms to workers;

3.Good age and yellowing resistance;

4.This product meet the standard of GB18583, ROHS, it is environmental friendly


1. Slabs treatment

Slabs should be totally dry.

Remove the mud, oil or other purity on the slab surface.

2. Prepare the glue and mix

Mix the glue by A:B=4:1(by weight) completely

Please use up the glue within the pot life. The glue will be fever and is prohibited to use when beyond the pot life. The more of the glue mixed, and the higher of the temperature, the shorter the pot life. If mixed too much glue, please divide quickly to use. 

Do not mix the cap of A and B. Please seal the caps anytime in case the moisture and dash from the air.

The plated with big open mouth container is recommend for glue mixing to extend the pot life of glue

3. Spreading the glue

Spread the glue evenly on the surface of slab with scrape back and forth. The recommend using weight is 80-150g/㎡。

For the cracks on slabs, spread glue back and forth to make the glue penetrate completely.

For the big defects on the slab, such as the soil, please remove first, then mix the glue and stone powder to fix it. Polish after cured, then spread the glue.

Please do not use the non epoxy and other slab surface treatment agent, or it will be not suitable for the epoxy glue spreading.

4. Glue solidify

The glue will be initially cured in 2-3 house under room temperature(25℃)It can be proceed to next procedure after 24 hours;

If possible, heat up the stone with adhesive to 50-60 ℃ and polish it after 2-3 hours.

Before the adhesive cured, the stone should be placed horizontally and not stacked; after cured, the lubricants such as talcum powder can be applied on the stone surface, to avoid stone adhesion when they are stacked.

5. Clean up

Use the specialized cleaner to clean the apparatus before the glue cured.

AZ-GL-6941 Slab Surface Epoxy
Long press to look detail
Long by picture save/share

enquiry form:

  • Please enter the verification code

enquiry content:

You have no items to require

Add Successfully

Anmyz Industry Limited


Add:No.28 Farm yard,Kangdian Village,Shuitou Town,Nan'an, Quanzhou,Fujian,China     

@copyright 2023 Anmyz Industry Limited

Service Center